Aircraft    W.I.P.    About    Contact    Downloads

 

While the PA-11 was not developed for use with SP2 alone, the aircraft package is useable if the following contact point (in red) is substituted for those in the aircraft.cfg. This will stop tailwheel bouncing.

[contact_points]
point.0=1, -15.71, 0.0, -0.64, 1800, 0, 0.256, 60.0,
0.025, 2.5, 0.75, 0.0, 0.0, 0.0, 0.0, 0.0
point.1=1, 0.96, -2.95, -4.51, 1600, 1, 0.70, 0.0, 0.111, 3.27, 0.21, 0.0, 0.0, 2.0, 0.0, 0.0
point.2=1, 0.96, 2.95, -4.51, 1600, 2, 0.70, 0.0, 0.111, 3.27, 0.21, 0.0, 0.0, 3.0, 0.0, 0.0
point.3=2, -0.86, -17.7, 1.80, 800, 0, 0.000, 0.0, 0.000, 0.0, 0.000, 0.0, 0.0, 5.0, 0.0, 0.0
point.4=2, -0.86, 17.7, 1.80, 800, 0, 0.000, 0.0, 0.000, 0.0, 0.000, 0.0, 0.0, 6.0, 0.0, 0.0
point.5=2, -17.00, 0.0, 4.50, 800, 0, 0.000, 0.0, 0.000, 0.0, 0.000, 0.0, 0.0, 9.0, 0.0, 0.0
point.6=2, 5.40, 0.0, -2.20, 800, 0, 0.000, 0.0, 0.000, 0.0, 0.000, 0.0, 0.0, 4.0, 0.0, 0.0

This change does not guarantee everything else will work as well as it will with Acceleration.

Many thanks to Frank Seigler for providing the new figure.